There is an incorrect concept in the market that all mosaic products are processed from stone trim or scrap, so the cost is very low, but it is not. Mosaic products are not equal to trim products: For mosaic products, if it is specifically for the purpose of digesting internal trim or waste, when it is not quantitative, a small amount of production and sales, it is only necessary to add a little material cost to the processing cost. However, when it is sold and produced as a mass production, a formal standardized product that meets the market demand on a large scale, or when it is supplied to a project with a large amount of engineering, the general edge material or waste cannot satisfy its requirements. Needed. At this time, to carry out normal production and supply, then only open the bulk material or open the waste material to achieve. Therefore, from this point of view, even if we adopt the method of purchasing cheap small materials for production, the cost is far less than that when using edge material production, and the concept of cost increases the weight. High-quality mosaic products of the same specifications are used in larger quantities than normal sheet materials: For the materials used in the mosaic products, if the level of high quality is to be truly achieved, it can be seen from the above production process that the actual materials used for the mosaic products of the same specification are larger than the actual materials used for the plates. Specifically, there are four points as follows: First, in the production process of the mosaic product particles, the plate (final media) needs to be opened into the required particles according to the requirements of the standard unit block, and the particles are small, but the knife width is larger, A plate is opened into a standard block, and the loss in the width of the knife may account for more than 15% of the loss, which is particularly prominent in the processing of small particle mosaic products. Second, the color of the materials used is basically the same. This requires the disposal of materials that do not conform to the color during the process of use, and the formation of a part of the direct loss; Third, in the process of material and vibration, due to inaccurate media or vibration and fracture, the direct loss of some materials, accounting for about 10%; Fourth, because the mosaic particles themselves are not all square or rectangular, they also have loss of utilization, which is more prominent in the mold products. Concerned about surprises Label: Is the material cost of stone mosaics low? Previous: What will be subverted by custom furniture? Next: Nursing knowledge of sliding doors Stevia Blends,Stevia Erythritol,Stevia Blends,Stevia Sugar JINING USP INTERNATIONAL CO.,LTD. , https://www.uspintl.com
Is the material cost of stone mosaics low?