Fault nature cause elimination method 1. The crankshaft bearing heating bushing is not well scraped. If the lubrication is poor, re-scrape the copper tile and check the lubrication. 2, the oil flowing out of the bearing has copper scraps lacking lubricating oil, the lubricating oil is not clean, check the lubrication, remove the bearing for cleaning 3, the guide rail cauterization guide rail gap is too small, poor lubrication, poor contact, re-scraping the guide rail, adjusting the gap, pay attention to lubrication 4. When the clutch is not combined or combined, the rotary health spring loses its elasticity after operation. Key matching too tight replacement spring, grinding button bonding gap 5. When the clutch is disengaged, the slider can't stop at the top dead center. The brake belt has insufficient pulling force, the brake belt is excessively worn, the oil wheel is slipped on the brake wheel, the brake spring tension is adjusted, the brake is replaced, and the brake belt is washed with kerosene. And round week 6. The material returning board does not work. The position of the material is not adjusted. 7. The connecting rod screw rotates or the impact locking device looses the rotary locking device The 8-link screw ball head has poor contact between the ball head and the ball pad gland in the slider ball pad. The gland screw loosely scrapes the ball head, the ball pad, and tightens the cap screw. 9 Press the button (on), no working, power off, hot power off, check the circuit system to eliminate the fault. Bulb Lights,Led Bulb Light,Usb Bulb Light,Plastic Led Bulb Shenzhen Huangtai Photoelectric Co.,Ltd. , https://www.huangtailed.com
Punch troubles and elimination