Many families choose to carry out their home improvement in the fall, because the autumn climate is relatively dry, the wooden boards are not easy to get wet, and the paint is easy to dry, but experts pointed out that autumn decoration should pay attention to moisturizing. First, avoid placing the wood in a ventilated place. In autumn, the climate is dry. After the wood is run to the decoration site, avoid placing it on the vents, and do the oil sealing on the surface as soon as possible, because the moisture content of the wood is adapted to the outside climate. If the wood is air-dried at the tuyere, the moisture in the wood will be quickly lost, the surface will be cracked, and small cracks will appear. Second, the wallpaper should be naturally dry. In the dry autumn, the wallpaper is usually soaked in water before being laid, and then the glue is applied. If the door and window are opened at this time, the wallpaper that has just been laid is dried by the "winding through the wind", the wallpaper will be lost quickly. Water, shrinkage and deformation. In addition, do not rush to fix the seasonal problems in the house. In summer, the air humidity is high, and the moisture contained in walls, floors and wooden furniture is relatively large. In the autumn, the air gradually becomes dry. At this time, the seasons may change. The changes in temperature and humidity may cause some problems, such as shrinkage of the wooden floor and increase of the gap between the board and the board. These are normal phenomena. For seasonal cracking on the wall, don't rush to fix it. The cracking of the wall indicates that the water in the wall is gradually volatilizing. If it is repaired at this time, the wall may continue to crack when the water continues to volatilize. Therefore, it is best to wait until the water in the wall adapts to the outside climate and then make a one-time repair. The simplest shape of the reinforcing ring is a rectangular column attached to the surface of the product, but in order to meet some production or structural considerations, the shape and size of the reinforcing ribs need to be changed as shown in the following figure. The position of the bottom of the product must be rounded to eliminate excessive stress concentration. The rounded corner design also gives the runner a gradual shape to fill the cavity with curvature. Problems such as water trapping will also lengthen the production cycle and increase production costs. Shield Reinforcement Ring,Tunnel Reinforcement Ring,Shield Tunnel Ring,Concrete Surface Of Ring Anshan Lijian Engineering Group Co. LTD , https://www.lijianformwork.com
Autumn decoration pay attention to "moisturizing"