AGLEX COB 3000W LED Grow Light is perfect for 5x6ft. The 1200w LED Grow Light is with veg and bloom switches, full spectrum for all stages of plants growth. Suggestion veg on only for seedlings vegging. Once into flowering, turn on both veg and bloom on, it will be bring you suprising response. Adavanced technology design, powerful light distribution. The 1200w led Grow Light is great for marijuana, herbs, flowers, vegetables. It also can be daisy chained with a cob 3000w or cob 600w to expand lighting area.
ADVANCED TECHNOLOGY - Aglex COB Reflector-series grow light, equiped with high-precision 90-degree reflectors and reliable COB Tech together, which can make sure 98% light souce can apply to your plants completely, make your plants healthier and happier.
LED Grow Light 3000W, Power LED Grow Light, 3000w LED Grow Light, 3000W Grow Light, Cob Grow Light Kit Shenzhen Ameri Technology Co., Ltd. , https://www.aglexz.com
HUMANIZED VEG & BLOOM DESIGN - This grow light veg & bloom switch setting allows you to switch on/off at any time for different growing stage, without unplugging, as well as keep an unnecessary electricity waste. Dasiy chain can help you to connect multiple lights, no worry about a tangled mess of wires.
EFFICIENT COOLING SYSTEM - Large aluminum heat sink and quality big fans cooler running make full spectrum growing lights give off very little heat as well as the LED grow light works in quiet, extending a longer service life of your light.
HIGH YIELD WITHIN LESS TIME - Aglex COB LED Grow Light full spectrum for indoor plants applies high power 50W COB and double chip LEDs which most closely mimics the natural sunlight and delieveries strong light, creating not only better plants, but reduced growing time and overall cost.
What Do You Get - 3000W COB Grow Light, US Power Cord, Hanging Hook Kit, User Manual, Our 3 years Worry-Free Warranty and Friendly Customer Service.
Oil drum pump usage and maintenance overview
1, New or long-term unused electric pump, measure the insulation resistance between all live parts and the metal parts that may be touched with a 500-volt megohmmeter after unpacking, and should not be lower than 7 megohms when approaching the working temperature. 2, before use, to check the terminals are solid, the ground wire must be reliable and solid. 3, check the power supply voltage is consistent with the rated voltage, can not exceed or lower than the rated voltage of 10% of the power used. 4, the use of the pump, do not damage the wires, to avoid water, oil into the motor, switches, electrical parts. 5, Prohibit the work under the conditions of containing flammable and corrosive gases to ensure safe production and the normal work of the electrical original. 6, if found in the use of abnormal noise, should immediately shut down, check the reason, until you try to exclude the rear can continue to use. 7, the pump should not be empty run, use the pump immediately stop pumping immediately, because the pump motor no-load speed of up to 10000 rev / split, otherwise it will be worn, universal joint impeller, serious damage to the pump tube. 8, replace the brush: brush wear can not be used immediately replaced, otherwise it will damage the commutator, a serious burn out the motor. 9, electric pump should be regularly checked, not as at least three months to check once-often used should be monthly maintenance, maintenance should be all open, eliminating internal dust, oil. If the commutator too much carbon can be used alcohol scrub commutator surface. If damaged parts should be replaced by the same parts. 10, when not in use, please be placed in a dry, clean environment without corrosive gases.