Non-professionals We know more or less about the construction methods of home-improvement tile, but that is usually implemented on the cement base surface. If it is on the wooden board tile it? There should be a lot of people do not understand. In fact, this is a new type of decoration concept. The following is the best way to introduce two types of tiles on the board . I hope to help friends with this need. First, the best way to tile on wood Method one: wrap the board and hang it on the barbed wire and start the building; then use a marble machine to cut a few holes on the back of the brick, put a copper wire in each hole, and then use the marble glue that you usually say to put the copper wire in the middle. The incision is fixed and exposed; the glue dry, the brick wall, and the copper wire is fixed to the backboard screw or nail. Second, in addition to this, it is also possible to nail a cement board on a wooden board, and then start building bricks, fix the cement board on the back board with screws, and then mix the cement with 901 glue. This is the best way to paste tiles on two kinds of wood boards introduced by Xiao Bian. Their effects are relatively strong and durable. Of course, this depends on how big your brick is. If it is a 200-300mm ordinary small brick, because of the low gravity, using glass glue is also possible. If nails are first put on the wooden board, the more dense the better and the outer leakage 1mm. This effect will be better, both to increase the contact surface and can play a leveling role; if it is 600mm or 800mm big brick, then in addition to the methods described above, you can also use AB glue paste, but remember to hang Barbed wire is essential, otherwise the effect will be greatly reduced. Therefore, we must pay more attention when choosing methods. Second, what stickers on the wood will not fall off 1, marble glue. This kind of glue was mentioned in the previous introduction of the method. In fact, it is what we usually refer to as marble glue. It can increase the contact surface and can play the role of leveling. Of course, the method should be used correctly. You can refer to the above content. 2, glass glue or structural adhesive plus double-sided tape (with sponge in the middle). The method is to use a double-sided tape on the brick first, to play a temporary fixed role, and then put on the glass glue or playing in the form of more than a few, stick on the tile on the line. Xiaobian epilogue: The above is the best way to put tiles on wooden boards and what tiles are used on wooden boards will not be lost. Tiles on the wooden floor is a professional technique. It is more difficult to lay tiles on the base. Therefore, it is recommended that everyone is best to ask a professional master to construct it to ensure its high quality and avoid future troubles! Aluminum Sheet Roll,Aluminium Slitting Coil,Aluminum Slitting Coil,Aluminum Rolled Coil Zhengzhou Yearshine Industry Co., Ltd , https://www.zzyscorp.com
The best way to paste tiles on a wooden board will not be lost