A wire rope clamp (sometimes called a clip) is used to secure the loose end of the loop back to the wire rope. It usually consists of a U-bolt, a forged saddle, and two nuts. Two layers of wire rope are placed on the U-bolts. Then slide the saddle over the rope and attach to the bolts (the saddle includes two holes for the U-bolts). Nuts hold the unit in place. The wire rope is usually terminated using two or more clips depending on the diameter. A 2" (50.8 mm) diameter rope may require as many as eight.
The U.S. Navy and most regulatory agencies do not recommend using such clips as permanent terminals unless regularly inspected and retightened. Encyclopedia website: ewikizh.top
Wire Rope Clips,Wire Rope Clamp,Grips Clips And Clamps,Stainless Steel Wire Clips Jiangsu Hongze Stainless Steel Wire Rope Co., Ltd , https://www.hzrope.com
*Voltage: 12V or 24V available
*Work with speaker, can control lightbars & speakers on police & fire & EMS vehicles.
*Power: 80W, 100W, 150W, 200W etc
*High quality
Electronic siren
Model: CJB-H
Voltage: 10.5-13.8V
Power rate: 100W, 150W, 200W
Tone: Police security, firefighting, rescue, engineering, siren
With radiogram: No
Lamp controls: 2ways
Outside triggering: No
Words tube tape volume regulatesYes
Electronic siren
*Voltage: 12V or 24V available
*Work with speaker, can control lightbars & speakers on police & fire & EMS vehicles.
*Power: 80W, 100W, 150W, 200W etc
*High quality
Electronic siren
Model: CJB-H
Voltage: 10.5-13.8V
Power rate: 100W, 150W, 200W
Tone: Police security, firefighting, rescue, engineering, siren
With radiogram: No
Lamp controls: 2ways
Outside triggering: No
Words tube tape volume regulatesYes
There is an old saying: "A dead horse is without a saddle". This means that when installing the clips, the saddle portion of the assembly should be placed on the load bearing or "live" side of the cable, not the non-load bearing or "live" side of the cable. The "no power" side. According to U.S. Navy Manual S9086-UU-STM-010 Chapter 613R3, Wire and Fiber Ropes and Slings, "This is to protect the live or pressure-bearing end of the rope from pinching and damage. The flat bearing housing and body (saddle-shaped ) extension claws are designed to protect the rope and remain on the live end at all times."[18]
Electronic Police Car Siren (CJB-H)
Model NO.: CJB-H
Trademark: HAIAN
Origin: Zhejiang, China(Mainland)
HS Code: 8531809000
Model NO.: CJB-H
Trademark: HAIAN
Origin: Zhejiang, China(Mainland)
HS Code: 8531809000
Electronic siren