Timing Belt with Punching Hole Changzhou Longfu Knitting Co., Ltd. , https://www.czcircularmachine.com
Have you used the right method to maintain the X-ray machine?
If the service life of an X-ray security inspection machine is longer, it is mainly to maintain and maintain the equipment. As long as the equipment is properly maintained, the equipment will basically not have any failures, and it will not be very big during operation. The problem. So how about good daily maintenance and maintenance? Tianyan security inspection machine manufacturers mainly introduce the following points.
(1) Keep the installation environment dry and not wet
Everyone knows that electronic products are afraid of moisture, and it is easy to short-circuit after being damp. Many users simply do not protect this step. The security inspection x-ray machine is made of electronic components, circuit boards, etc. The main components of which are organic electricity, electronics, and optics. If the environment is wet, it will affect the dampness and cause some components to rust. If it is light, the circuit parameters will be changed or the mechanical parts will be ineffective. In severe cases, the machine parts will be burned out due to short circuit, or the electric shock will be formed due to the decrease in insulation strength. Therefore, the environmental requirements of the X-ray security inspection machine are very important. Moisture-proof measures must be taken to keep the environment dry and do not allow the equipment to get wet. Only in this way can the normal operation detection of the machine be ensured, thereby prolonging the service life of the machine.
(2) External cleaning of security inspection equipment
The security inspection x-ray machine is used to detect passengers' luggage. The equipment is placed in public places. It will inevitably be dusty after a long time. You should also pay attention when scrubbing. Try not to scrub with wet towels. If you use wet towels to scrub the equipment It should be measured with no water or less water, and there is no need to wipe the machine with a damp cloth. Use a dry towel to wipe out the dust, so as not to drip into the machine, the equipment is damp and cannot be used normally. So pay attention when wiping the device.
(3) Internal cleaning
The X-ray security inspection machine must be not only moisture-proof, but also dust-proof. If dust enters the interior of the machine, it will also cause the security check X to shut down and short-circuit, so dust-proof is also an important measure to ensure the normal operation of the machine. Dust will make some electrical components in poor contact, form a short circuit, and affect the normal operation of the machine. Even burn out the machine. When cleaning the external dust, use a vacuum cleaner; and the dust inside the machine should be cleaned with an electric hair dryer and a fine brush, never wipe it with a damp cloth. Some parts can be covered with a cloth cover to achieve a very good dustproof effect.