We diviided the led light according to the using eviiroment. Most of our product is the commercial LED Lighting
Commercial lighting is a term used to describe lighting that is used in commercial spaces, including auto dealerships, distribution centers, churches, factories, offices, and warehouses. Unlike residential lighting, commercial lighting is made to withstand more abuse and has a longer lifespan.
While the focus of residential lighting is often on aesthetics, commercial lighting is task orientated. Commercial lighting systems are designed based on what the application is. For example, in an office-type setting, you may see task lighting, which illuminates specific areas where employees need concentrated light to be able to perform their jobs.
Cylinder Ceiling Light,Ceiling Lights For Living Room,Black Ceiling Light,Led Ceiling Lights Dimmable Jiangmen Dilin Lighting High-Tech Co., Ltd. , https://www.jmdilinlight.com
2 Check if there is too little or too much interference in the lower knife. In general, the clearance of the lower knife should be kept at about 0.2 mm;
3 Check whether the electromagnetic reversing valve is not reversed, and check the connection status of the line and the condition of the electrical device. If the electromagnetic reversing valve is faulty, replace it.
Second, the steel straightening machine cut constantly or sometimes cut constantly 1 Check the cut off with high pressure conditions, such as cutting off the high pressure abnormalities should be compared with the instructions to adjust the pressure;
2 Check if there is excessive clearance between the upper and lower blades. If any difference is found, adjust it to about 0.2 mm.
3 Check whether there is a short adjustment of the delay disconnection time and relay time. If there is any difference, it should be set to 0.2~0.4 seconds.
4 Check whether the strength of the bar to be cut is too high. The user can cut the bar previously cut off and cut it again on the machine so that the strength of the bar to be cut can be more than 750N.
Third, the steel straightening machine does not cut 1 Check the solenoid valve for damage or debris, if found damaged, it should be replaced, if found inside a foreign body, remove it after cleaning it;
2 Check whether the AC contactor (KA2) has burned out at the start point. If the above problem is found, it can be repaired or replaced.
3 Check if the proximity switch is damaged. If the above problem is found, replace it.
4 Check whether the ZJ intermediate relay is damaged. If you find the above problem, you can replace it.
The reason why the steel bar straightening machine does not cut off and the solution
1. After the steel bar straightening machine is turned on, the upper knife does not come back 1 Check whether the oil pipeline is correctly assembled and assemble it against the instructions.