shanghai NuoSai pump is a professional manufacture of Vertical Multistage pump, the PMP/PMPA series high quality stainless steel vertical multistage pumps have a more good performance than CDL/CDLF Vertical Multistage pumps.Compaired with CNP, Groundfos, wilo,Leo ,ebara,ksb etc,PMP/PMPA vertical multistage pumps is more economic choice Vertical Multistage pump,stainless steel vertical Multistage pump,CDL Vertical Multistage pump,High pressure booster pump,CDLF Vertical Multistage pump Shanghai NuoSai Pump Manufacturing Co., Ltd. , https://www.nuosai.net
What is the reason why the oil temperature of Hanse Gasoline Generators is too high and the consumption is high?
How is the oil temperature too high and the consumption too large during the use of automatic gasoline generating units? If the fuel consumption of the generator set is too large, it will lead to waste of oil for the generator set. And gasoline generator set fuel consumption is a small cost. What should we do about this situation? The following full-power introduction describes the causes of diesel oil generator set's high oil temperature, too much consumption and how to eliminate it.
First, the oil level in the oil pan drops rapidly, the oil color is darker, and the fumes from the ventilation pipe are taken as smoke, and the exhaust smokes blue smoke.
1. The oil return hole of the piston oil ring is blocked by carbon deposits, cleans the carbon deposit or replaces the oil ring.
2. The turbocharger turbocharger elastic seal device fails and the dismantled elastic gas seal ring is sintered and elastically ineffective. Otherwise, it should be replaced.
3, the use of the oil brand is not appropriate, please select the required brand number.
4. The piston ring is stuck or damaged. The cylinder sleeve is damaged so that the oil can enter into the combustion chamber, the gas enters the crankcase, the piston ring is replaced, and the cylinder sleeve is replaced if necessary.
5, long-term low-load operation, increase the load properly.
Second, the oil temperature gauge reading exceeds the specified value, after cooling is still higher, while the exhaust black smoke
1. The gasoline generator is overloaded and the load should be reduced.
2. The oil cooler or radiator is blocked and the cooler or radiator circuit is cleaned.
3, the amount of cooling water or fan air flow is insufficient, pay attention to make the cooling water flow and adjust the tension of the triangular rubber belt so that the Water Pump and fan reach the specified speed.
4. Insufficient oil capacity, add oil to the specified plane.
5, thermometer instructions are not accurate, school hard or replace.
The reason why the oil temperature of the automatic generator set is too high and the method of troubleshooting is very clear. It is hoped that it will help the user.