Specializing in the troubleshooting and quick repair of the sales automation dispensing machine during actual use Shower Valve,Shower Faucet,Thermostatic Shower,Shower Handle Moon Shower Sanitaryware Co.,Ltd , https://www.moonshowerglobal.com
: In our actual production process of the dispenser, it is inevitable that some problems will occur, especially if the machine is used for more than a certain period of time. Hengling Dispensing Robots has listed the most common problems and quick troubleshooting methods based on years of experience in the professional production of dispensing machines and maintenance experience.
1: The problem we often encounter is that there is no glue problem. The solution is to first check whether the voltage supply of the solenoid valve is normal. In the case of normal power, it is definitely a problem of the solenoid valve. Just look for it. The new solenoid valve can be used. The main reason for this problem is that the suction is too large during the normal use of the dispenser, and the glue is sucked back into the solenoid valve so that the electromagnetic is accumulated after a certain period of time. The valve is easy to break.
2: The dispenser is turned on normally, the program is normal, but when the start button is pressed, the machine will suddenly power off and then reset immediately, then press the start and then power off and reset. The solution to this problem is to check the short circuit of the line connected to the power supply. This situation is easy to find on the dispenser that has been used for a long time. The dispensing machine produced by Hengling Dispensing Robot Co., Ltd. The connecting lines are all made of well-known high-flexible and anti-folding cables, and the national standard of the core wire is 0.5mm^2 and above. It is easy to prevent aging, short circuit and other phenomena in 3-5 years.
3: The dispenser is turned on normally, the program is normal. However, during the movement, the Z-axis will not move according to the programmed route, but the upper and lower jumps and the Z-axis directly drop and jam. The reason for this problem is mainly because there is no three-phase motor in the motor used on the dispenser. One of the wires is connected to the other two wires. You only need to check which one of the wires is disconnected one by one. The open line is connected to work normally.
Hengling Dispensing Robot Co., Ltd. produces dispensers, such as motors, guides, lead screws, power supplies, solenoid valves, wires, and push buttons, all using internationally recognized brands to ensure the service life of the machine is 5-8. year
Http://news.chinawj.com.cn Editor: (Hardware Business Network Information Center) http://news.chinawj.com.cn
Trouble shooting and quick repair of the dispenser during actual use