Chlorine dioxide generator precautions

A simple, high conversion, high purity, multi-purpose, environment-friendly chemical medium and small-scale chlorine dioxide multi-stage generator. This chlorine dioxide generator is composed of a tank reactor through an acid-resistant conduit and a water-jet vacuum unit. The tank reactor uses a two-stage or multi-stage reactor. The main reactor is equipped with an air distributor. The auxiliary reactor is equipped with a balance tube to make the reaction more thorough. The residual liquid after the reaction can reach the standard discharge. The resulting chlorine dioxide can be prepared as an aqueous solution, and a stable chlorine dioxide solution can also be obtained.

Precautions
1. Before the first run, sufficient fresh water must be added to the equipment, and no empty machine is allowed to operate;

2. When the metering pump stops feeding, the ejector should continue to operate for more than one hour, so that the chlorine dioxide gas in the reactor can be fully evacuated to avoid gas overflow from the inlet pipe.

3. If the power source suddenly stops water, the metering valve should be closed immediately.

4. Hydrochloric acid is a strong acid. Operators should wear protective gloves. The raw material NaCLO2 is prohibited from being stored together with various kinds of acids and away from fire sources.

5, equipment temperature control tank should be frequently replenishment, to prevent damage to the heater, the controller has a protective device, when the tank water level is lower than the set value, the control cabinet on the fault light, immediately replenishment.

6, chlorine dioxide has a strong oxidizing, soft plastic pipe equipment, easy aging and sealing is not strict, should be regularly checked and replaced.

7. Periodically clean the sediment in the reactor. If it is found that the liquid level of the reaction level tube exceeds the normal limit, it means that the sediment is too much and should be flushed immediately. And check the quality of raw materials.

8, in the case of raw materials containing impurities are easy to plug should pay attention to clean up.

9. The equipment is heated by a water bath. When the equipment is not in use, the water is heated and the reaction liquid is let off to prevent freezing at temperatures below 0 degrees and damage the equipment. If the equipment is used intermittently, to keep the heated water and the reaction liquid from freezing, keep the temperature control box working continuously.

Komatsu Electrical Parts

Komatsu Electrical Parts,Komatsu Forklift Parts,Excavator Electrical Parts,Quality Komatsu Electrical Parts

JINING SHANTE SONGZHENG CONSTRUCTION MACHINERY CO.LTD , https://www.stszcmparts.com