In the midsummer, the most favorite wind and rain, the heavy rain washed away the pollution of the heavens and the earth, but also the sweltering heat can be swept away. Sitting in front of the window and looking at the world outside, always feels very happy. Someone joked that this joy comes from the affluent feeling that the primitive people hid in the hole and looked at the raining animals outside the cave. Indeed, shelter from the wind and rain should be the most basic function of the home. The waterproof and insulated exterior wall is like a protective cover to protect the family from the wind and rain. If you have a comfortable house, if there is a sudden leak in the roof, water seepage on the window sill, or even mildew on the wall, there will be no “richâ€. To completely solve these tough troubles, you need to find the disease and prescribe the right medicine. Let the love of the rainy season stay dry and clean. Crack the roof leaking strategy Although there are many specific reasons for leaking roofs, in general, it is mainly due to the following situations. The waterproof layer upstairs (or roof) was damaged. This reason is very common, and it is also the real reason for the leaking roof in many people's homes. The solution is to find the missing area, make up the waterproof layer (if the top floor needs to do the outer wall protection), this will solve the roof leakage. The pipe is broken. Because every floor has to be connected to the pipeline, including domestic water, heating, sewage pipes and so on. Sometimes the roof is leaking due to insufficient contact between the pipe and the floor. It can be determined according to the water seepage position whether the pipe is broken. After determining the good cause, the property or specialized maintenance unit can be targeted for special treatment. It should be noted that the problem of water leakage on the roof should be solved early, otherwise, the long-term flooding of the ceiling will only increase the difficulty of maintenance and make it more complicated to handle. Cracking the water seepage of the outer window Some readers have reported that the rain has been frequent recently. Although the house has paid attention to closing the window to prevent rain, it is always inexplicable to appear in the vicinity of the window. I don't know where the problem is. The reporter learned through interviews that if the window sealant cracks, even if there is no sealant around the window frame during the decoration, the window sill is prone to rain leakage. Over time, the skin around the window will fall off due to moisture. In severe cases, even dripping water, causing the floor furniture to be soaked. It is understood that if the window glass sealing strip is found to have a gap, or the surface has obvious scratches, it indicates that the window is not tightly sealed, and it is necessary to deal with it in time. In daily life, it is necessary to diligently check the sealing of the window and the periphery of the door frame, and the gel should be glued and replaced in time. In addition, the window frame is preferably made of a material with good sealing properties. It is not advisable to put a discharger on the side of the window. The furniture at the window should be as high as possible. If there are conditions, you can choose to make the cabinet. In general, out-of-window processing is more important than in-window processing. Crack the wall moldy Raiders If there are drums, blisters, moldy, wall peeling, etc. on the interior wall, the wall is already defective. The wall skin is peeling off, most afraid because the outer wall is not waterproof or the waterproof layer is cracked, which causes the rain to erode the outer wall. The brick inside the wall absorbs water and forms the inner wall skin moldy or even falling off. Because ordinary cement bricks absorb a lot of water, the rainwater is stored in the wall and when it is full, it begins to penetrate into other areas. To completely solve the problem of water ingress into the wall, it is necessary to wait for the rainy season after the rainy season, and then first solve the problem from the outside and redo the waterproof layer. Then do the internal processing.
Sunplus Abrasives Co.,Ltd is a leading company in the field of researching and manufacturing premium quality coated abrasives for a wide range of applications. Sponge Sandpaper,Abrasive Sanding Belt,Sanding Blocks Abrasives,Abrasives Sponge Sandpaper GUANGZHOU SUNPLUS TECHNOLOGY CO.,LTD , https://www.sunplussandpaper.com
Founded in 2004, Sunplus has developed into an enterprise with the leading fully - automated Germany system production line and technology to make high and stable quality sandpaper. All our materials are imported from Europe, Japan and Korea, which assures high quality products from the source.
We constantly invest in research and development so as to ensure that our products will always be a step ahead of competition.
Rainy season home waterproof Raiders
Sunplus Sponge is made with aluminum oxide and latex paper with foam backing. Aluminium Oxide grains provide fast sanding results. The foam backing is suitable for hand sanding of corners, angles of car body parts. The foam allows pressure to be applied evenly and thus reduces the risk of sanding through the surface.