It is also the season of spring blossoms, and spring is a great season for family decoration. Because everyone knows that "spring" is the best annual renovation stage. If you don't pay attention to the construction essentials, it will be counterproductive and bring certain quality hazards or losses to your decoration. Therefore, pay attention to the following seven aspects when renovating in the spring: 1. It is not allowed to use warehouses that are not stored in winter or piled up outdoors, covered with rain and snow, plates, and other synthetic boards related to wood, because its dry humidity is difficult to detect and observe. Most of these materials are dry on the surface. However, the inner surface is damp, and the spring breeze is extremely easy to be deformed, which can leave hidden troubles on the wood products or the wall surface and cause cracking and squeezing after the decoration. 2, the proportion of cement and yellow sand can not be too large, many people think that the cement ash number is the better when the tile is pasted, this is actually wrong. The ratio of cement to yellow sand should not be less than 1:1.5, especially in the spring. If the cement ash number is too large and causes too fast shrinkage, cracks appear on the surface of individual low-quality tiles. 3, tile immersion time should be relatively long: due to the spring spring wind is large, the indoor wall is relatively dry, water absorption is fast, so the wall must be properly watered before the tile is pasted, according to the material, the degree of immersion should be moderate Adjustment, it is best to soak for more than 5 seconds to prevent the tile from drying and shrinking too quickly after the wall to maintain the solidification strength of the cement. 4, wood production, the seam and interface between the board and the board must be tighter than usual, and should be closed with the primer as soon as possible to prevent the spring breeze from causing the material to shrink, pull the seam, and open the split corner. 5, the joint between the gypsum board and the gypsum board, the filling of the caulking gypsum must be double-filled, the bandage paste is best used twice, and it is better to use the white glue to prevent the surface crack after opening the window or during the heating period. 6. When the wall is shaved, the opening time of the doors and windows should not be too long. The dryness of the house will cause the skin to crack and crack. At the same time, when debugging the white material, the proportion of the gypsum powder must be increased, the adhesion of the white is strengthened, and the turtle is prevented. Crack phenomenon. 7, when spraying paint should pay attention to the indoor humidity, the ground should always be sprinkled water, to prevent too dry, too much dust, resulting in oily surface pitting or uneven small particles phenomenon. Silicone Lamp,Kids Night Light,Colorful Silicone Lamp,Rechargeable Silicone Lamp Yuyao Flylit Appliance Co.,Ltd , https://www.flylitlight.com
Spring decoration tips