LED-illuminated LEDs are made of III-IV compounds, such as GaAs (gallium arsenide), GaP (gallium phosphide), GaAsP (phosphorus gallium arsenide) and other semiconductors, the core of which is the PN junction. Therefore, it has the IN characteristic of a general PN junction, that is, forward conduction, reverse cutoff, and breakdown characteristics. In addition, it has luminescent properties under certain conditions. At the forward voltage, electrons are injected into the P region from the N region, and holes are injected into the N region from the P region. A part of the minority carriers (small children) entering the other area is combined with the majority carriers (multiple sub-) to emit light. Assuming that luminescence occurs in the P region, the injected electrons directly composite with the valence band holes to emit light, or are first captured by the luminescent center and then condensed with the holes. In addition to this luminescent composite, some electrons are trapped by the non-luminous center (this center is near the middle of the conduction band and the intermediate band), and then recombined with the holes, and the energy released each time is not large, and visible light cannot be formed. The greater the ratio of the composite amount of luminescence to the non-luminous composite amount, the higher the photon efficiency. Since the recombination emits light in the minority carrier diffusion region, light is generated only within a few μm of the PN junction surface. Theory and practice have proved that the peak wavelength λ of light is related to the forbidden band width Eg of the semiconductor material in the light-emitting region, ie λ≈1240/Eg(mm) The unit of Eg in the formula is electron volt (eV). If visible light (wavelength between 380 nm and 780 nm red) is produced, the Eg of the semiconductor material should be between 3.26 and 1.63 eV. Light longer than the wavelength of red light is infrared light. There are now infrared, red, yellow, green and blue light-emitting diodes, but the blue light diodes are expensive and expensive, and are not commonly used.
Soap Holder,Shower Soap Holder,Bathroom Basket,soap dish,stainless steel soap rack,etc
WELL DESIGN: Cambered surface Slotted design soap dish, Self Draining, Stylish and functional, Porous design lift to air drying faster
DURABLE CONSTRUCTION: Soap case holder made from 304 stainless steel, get best care to your skin
STYLISH MODERN: Let your bathroom become more simple and upscale!Applicable to families, hotels, home stay and other places to use.
bathroom basket,bathroom rack,bathroom shelves,shower rack,storage basket Shenzhen Lanejoy Technology Co.,LTD , https://www.grill-grid.com
LED lighting principle