In home renovations, paving tiles are almost a must for every family. Although the owners do not participate in the construction, it is a good thing to understand the process of laying bricks. Floor tile quality In general, to achieve the desired laying effect, the quality of the floor tiles accounted for 70%, ceramic laying techniques accounted for 30%. Without a good floor tile, it is difficult to obtain good results even if it is laid; but even if there are high-quality floor tiles, floor tiles are wasted if they are not laid. Paving tiles should be carried out according to the following work: correct steps for paving tiles First, according to the design requirements, according to the floor tiles color, pattern, etc. try spelling number. Remove floor tiles with cracks, missing corners, warpage, and surface defects. The tiles are then wetted with water and the surface is wiped dry. When the cement mortar is used as the binding layer, the volume ratio of the cement sand should be about 1:5, and the water should be mixed evenly. The thickness of the bonding layer should be about 3cm; the bonding layer and the floor tile should be paved at the same time, and the cement slurry or dryness should be used when paving. Sprue sprinkler for bonding. The paved tiles should be flat, straight and inlaid correctly. After each tile is inlaid, lightly tap the four corners and centers of the tiles with small round sticks to ensure that the bricks are in complete contact with the cement mortar and the tiles are guaranteed. Flat ground. The surface of the floor tile shall be clean, smooth and solid; the width of the joint between the porcelain plates shall meet the design requirements; when the design is not specified, the width of the joint shall not be greater than 2 mm. In practice, in order to reduce the seam width, strict engineering requires the application of glass glue on the four corners of the floor tiles. There are two purposes. First, the glass glue can prevent penetration, and the glass glue color is Transparent, therefore, can be the seam between the floor tiles and floor tiles in the most effective way to cover up; Second, effectively prevent the floor tiles from heat ups and downs. After laying the floor tile, the surface of the tile shall be protected. After the strength of the cement mortar of the bonding layer meets the requirements, the first cleaning will be performed and the wax will be smooth and bright. Floor Tile Villa Design Cement Glass Decoration Design Home Decoration Glass Brick Craft Glass
Decoration Must See: The Right Steps for Paving Tiles