1. Operate by an operator who is trained and familiar with the structural performance and operating procedures of the injection molding machine. 2. Operate the plastic machinery strictly according to the requirements of the operating procedures, and must not carry out illegal operations in non-operating stations. To ensure the reliability of the safety device, the safety protection measures of the machine must not be destroyed for efficiency. 3. The injection molding machine should use the hydraulic oil with the cleanliness, viscosity and other indicators to meet the requirements, and provide sufficient cooling water for the oil cooler according to the regulations, so as to avoid the hydraulic components and pipelines from blocking or leaking due to oil pollution or high temperature. And so on. The extruder should be filled with the required lubricant. 4. Do not use low-quality materials with metal impurities or sediment. Do not place metal objects that may fall into the vicinity of the feed port to prevent the screw or barrel from being abraded or jammed or damaged. 5. When the material temperature has not reached the set temperature, when the holding time is not enough, it is not allowed to start the screw. 6. In case of malfunction or abnormal situation, the relevant personnel must be reported and handled by professional maintenance personnel. If it is found that there is an abnormal phenomenon affecting safety, immediately press the emergency stop switch. 7. Pay attention to fire safety. Fire extinguishers should be placed near equipment that uses heat transfer oil. Concerned about surprises Label: Regenerative granulator operating procedures and maintenance techniques Previous: IHF series fluoroplastic lining chemical pump operation and protection Next: Common troubleshooting of elemental analyzer Sticker Tiles For Walls,Bathroom Tile Decals,Tile Decal Stickers,Tile Stickers For Wall Fancy Tiles Co,. Ltd. , https://www.tilefancy.com
Regenerative granulator operating procedures and maintenance techniques