Door Motor,Roller Door Motors,Garage Door Motor,Multiple Door Motor Caesar door control co.,ltd , http://www.caesar-door.com
When the surface is sprayed, there may be small defects on the surface of the paint film such as coarse grain, sandpaper mark, flow mark, white paper, orange peel, etc. In order to compensate for these defects, it is usually polished and polished after spraying to improve the paint film. The mirror effect achieves the requirements of brightness, smoothness and brilliance. Here we take a look at the operation method and maintenance knowledge of the automatic polishing machine.
Automatic polishing machine operation method:
1. Unplug the power cord. Check the power cord for damage and leakage. Check the power supply.
Whether the various parts of the polishing machine are filled.
2. Install a suitable polishing pad on the automatic polishing machine.
3. Sprinkle the maintenance wax through the sprayer to the ground. (Do not spray too much on the maintenance 蜻, otherwise the ground will fog)
4. Slowly move with a sorghum polishing machine to polish the ground. (If the silver is worn, replace it in time)
5, between the line and the line to overlap one third, so as not to miss the throw.
6. Use the ground to remove dust.
7. After using the polishing machine, remove the chassis needle holder and the scouring pad and wash it, and wipe the machine parts. Wash all the tools and put them back.
8. Keep the mark until the floor is completely dry.
Maintenance of automatic polishing machine:
1. After use, clean the parts such as the machine disc;
2. Wipe the machine, wires, etc. with a rag and wrap the wire around the hook.
3. Always add oil to the spare parts of the moving part to make it lubricated.
4. After use, store in a place where air is flowing and dry.
Automatic polishing machine, polishing machine operation method and maintenance