The two-way pressure butterfly valve can be used in a wide range of applications (municipal engineering, papermaking, petroleum, chemical, oil depots), especially in applications where the pressure requirements of the valve are high. So, what should you pay attention to when using the two-way pressure butterfly valve ?
Earth Drill and universal entensively used for the temporary anchoragein in the transimission line construction, while our Ground Anchor serves to fix th ewinch,pull tensioner,turning block and the temporary guy wire among others.
Our SDM series ground anchor is a tool for temporary anchorage during the transmission line construction. It serves to fix the winch, puller tensioner, turning block, and the temporary guy wire, among others.
This product is designed with the steel plate welded structure. Its surface is coated with the antirust paint, thus offering high durability.
Our GZ series Universal Steel Pile is suitable for the temporary anchorage in line construction.
Usage
When in use, our product will be firstly buried under a certain depth of ground anchor pit. Next, the stranded wire or Steel Wire Rope fixed on this product will be obliquely led out from the pre-dug riding track. After the hole is filled with soil and then the soil is tamped down, this product can bear the load.
1. The valve should be blocked at both ends of the valve and stored in a dry, ventilated room. If it is stored for a long time, it should be checked regularly.
2. Clean the valve before installation to eliminate defects caused during transportation.
3. The markings on the valve must be calibrated during installation. In particular, the flow direction of the media must be consistent with the flow direction marked on the valve.
4. For electric disc valves, it should be noted that the connected mains voltage must be the same as in the electric device manual.
Possible failures, causes and elimination methods of the two-way pressure butterfly valve:
1. Leakage at the packing
The nut of the packing platen is not tightened or the screwing is uneven, and the nut can be properly tightened. If you find that you continue to leak, you may fill
The amount of material is insufficient, and the packing can be refilled and then tightened.
2. Leakage of valve body and disc seal
1) There is dirt between the sealing surfaces, which can be cleaned.
2) Damage to the sealing surface, re-grinding or re-grinding and grinding the valve body after welding.
3) The eccentric position is not suitable, and the eccentric position is adjusted to the appropriate position during installation.
This article is reproduced from: http://
Earth Anchors Applied In Construction
Earth Drill, Universal Steel Pile, Spiral Ground Archor, Ground Anchor,Universal Bearing Piles
NINGBO MARSHINE POWER TECHNOLOGY CO., LTD. , http://www.marshine-power.com